This video describes a circuit that uses solar panels to switch power to solar power in the event of a power outage in a typical home. Solar power to home, How to wiring solar panel, Solar power auto changeover system, Solar ATS
The power generated from the Solar Panel is supplied to the Solar Charging Control via a 2 pole isolator MCB.
Solar Charging Control is done to keep the power required to charge the battery constant and to prevent damage to the battery from overcharging.
The 12 v DC power output from the Solar Charging Control is fed to the battery through a fuse that supplies the battery voltage to the inverter and the inverter produces 230 v of electricity.
In the event of a power outage in a house, this method can only light the light bulbs in the house. LED light bulbs are more suitable for this purpose.
This system can be used to supply electricity to the whole house using a high voltage solar panel. This circuit is very useful in case of power failure in a normal house. This circuit can be designed at a very low cost.
* Care should be taken to select Charging Control, Battery, Inverter suitable for the capacity of the Solar Panel you choose
* One or more solar panels can be used for this circuit.
**This circuit produces 230 v of electricity, so care must be taken**
**The inverter system automatically turns on when the mains supply is disconnected.. No time delay.
****Main contactor (main supply)auxiliary point 2 should be N / C (normally closed ) **
****You can buy such a contactor in the market or you can use auxiliary contact block.***
****Thanks for watching video please subscribe my channel.
Watch out: **electrical wiring is very dangerous**you could be shocked or killed. If you are not trained and familiar with proper, safe electrical wiring practices don't try it.
